Is The Maintenance The Same For Different Types Of Helical Gear Reducers?

- Nov 07, 2020-

When installing the helical gear reducer at the beginning: why do you need to pay attention to the center axis of the machine, which can not only extend the service life of the helical gear reducer, but also ensure that the machine has good transmission efficiency, and the error of the central axis is not greater than that of the coupling amount of compensation. When installing the shaft transmission parts, use assembly tools to install the transmission parts in the correct way to ensure the integrity of the internal parts of the helical gear reducer. When choosing a fixed coupling, the manufacturer has decided not to use steel material. If this steel material is improperly installed, the machine will not work properly.

   After the installation of the helical gear reducer, an effective and comprehensive inspection must be carried out to check whether the installation positions of the transmission components of the machine are correct to ensure that the machine can run normally. Before operation, the oil level of the helical gear reducer should be filled until it flows out from the plug screw hole, and then the reducer should be tested for about 2 hours without load. When the machine can run smoothly, there is no vibration, no impact, no noise, no oil leakage, it means that everything is normal, and the oil level of the machine needs to be checked regularly.

   The smoothness of the helical gear reducer depends on whether the base is firm, so as to ensure that the reducer does not have vibration and noise during operation, and can protect the shaft and gear from damage. If the transmission of the helical gear reducer adopts gears or sprocket as the transmission, it is necessary to install a protective device for the machine to ensure that the output shaft can withstand a large amount to protect the safety of the machine.